Waiting Time For The Scanner To Enter Power Saving Mode [Power Saving] - Fujitsu fi-8190 Operator's Manual

Waiting Time for the Scanner to Enter Power Saving Mode [Power saving]

Specify the waiting time before the scanner enters power saving mode.
1
Start up the Software Operation Panel.
For details, refer to
2
From the list on the left, select [Device Setting].
3
Specify the waiting time for the scanner to enter power saving mode.
Power saving
Use the slider to specify the waiting time before entering power saving mode in the range from 5 to 115
minutes (in increments of 5).
The factory default setting is "15" minutes.
[Power off after a certain period of time] check box
Select this when you turn off the scanner automatically.
When this is selected, the scanner is turned off automatically if it is left on without being used for a
certain period of time.
The check box is selected for the factory default setting.
You can select the timeout period for the scanner to be automatically turned off by [1 Hour]/[2 Hours]/[4
Hours]/[8 Hours].
The factory default setting is [4 Hours].
Starting Up the Software Operation Panel (page
Scanner Settings (Software Operation Panel)
333).
390