Situation In Which The Document Is Not Fed Into The Adf Occurs Frequently - Fujitsu fi-8190 Operator's Manual

Situation in Which the Document Is not Fed into the ADF Occurs Frequently

Check the following points
● Do the documents meet the paper requirements? (page 317)
● Did you fan the documents before loading them? (page 317)
● Are the brake roller and pick roller installed correctly? (page 317)
Are the brake roller and pick roller clean? (page 317)
●
Are the brake roller and pick roller worn out? (page 317)
●
If the problem still persists, check each item in
330) first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
●
Do the documents meet the paper requirements?
Solution
Use documents that meet the requirements.
For details, refer to
●
Did you fan the documents before loading them?
Solution
Fan the documents.
For details, refer to
●
Are the brake roller and pick roller installed correctly?
Solution
Install the brake roller and pick roller correctly.
For details, refer to
●
Are the brake roller and pick roller clean?
Solution
Clean the brake roller and pick roller.
For details, refer to
●
Are the brake roller and pick roller worn out?
Solution
Check the counters for the brake roller and pick roller.
● For fi-8190/fi-8290/fi-8170/fi-8270
Check the counters for the brake roller and pick roller with one of the following methods.
Documents for Scanning (page
Preparing Documents to Load Them in the ADF Paper Chute (Feeder) (page
Replacing the Brake Roller (page 233)
Daily Care (page 214).
317
Before You Contact the Scanner Service Provider (page
117).
and Replacing the Pick Roller (page
Troubleshooting
111).
238).