Scanner Settings (Software Operation Panel); Starting Up The Software Operation Panel - Fujitsu fi-8190 Operator's Manual

Scanner Settings (Software Operation Panel)

This section explains how to use the Software Operation Panel to configure the scanner settings.
With the Software Operation Panel, you can configure settings for operations of the scanner and management of
the consumable parts.

Starting Up the Software Operation Panel

Start up the Software Operation Panel in the following procedure.
ATTENTION
● Do not start up the Software Operation Panel during scanning.
● If you change the Software Operation Panel settings while the scanner driver window is displayed, the changes
may not be applied immediately. In that case, close the scanner driver window and open it again.
● Do not use the operator panel while the Software Operation Panel is running.
1
Make sure that the setup process for the scanner is complete, then turn on the scanner.
For details about how to setup the scanner, refer to
For details about how to turn on the scanner, refer to
2
Display the [Software Operation Panel] window.
● For Windows Server 2008 R2/Windows 7
Click [Start] menu → [All Programs] → [fi Series] → [Software Operation Panel].
● For Windows Server 2012
Right-click the Start screen, and select [All apps] on the app bar → [Software Operation Panel] under [fi
Series].
● For Windows Server 2012 R2/Windows 8.1
Click [↓] on the lower left side of the Start screen and select [Software Operation Panel] under [fi Series].
To display [↓], move the mouse cursor.
● For Windows 10/Windows Server 2016/Windows Server 2019/Windows Server 2022
Click [Start] menu → [fi Series] → [Software Operation Panel].
● For Windows 11
Scanner Setup (page 40).
How to Turn the Power ON (page
333
72).