Specifying The Sensitivity Level For Vertical Streak Detection [Vertical Streak Sensitivity] - Fujitsu fi-8190 Operator's Manual

Specifying the Sensitivity Level for Vertical Streak Detection [Vertical Streak
Sensitivity]
Specify the sensitivity level to detect vertical streaks (dirt on the glass) when [Enable] is selected for [Vertical Streak
Detection].
Adjust the sensitivity level according to how dirty the glass is.
1
Start up the Software Operation Panel.
For details, refer to
2
From the list on the left, select [Device Setting 2] → [Vertical Streak Sensitivity].
3
Select the sensitivity level to detect dirt on the glass.
Low
Decreases the sensitivity level to detect dirt on the glass.
Specify this to detect dirt only when the glass is very dirty.
Normal
Detects dirt on the glass with the optimum sensitivity.
This is the factory default setting.
High
Increases the sensitivity level to detect dirt on the glass.
Specify this to detect dirt even when the glass is slightly dirty.
HINT
● If [Clean glass!] frequently flashes on the second line in the [Ready] screen, select [Low].
● For fi-8190/fi-8290/fi-8170/fi-8270, this setting can also be configured in the operator panel.
Starting Up the Software Operation Panel (page
Scanner Settings (Software Operation Panel)
333).
397