Feed Mode Switched; Sensor(S) Dirty - Fujitsu fi-7300NX Operator's Manual

If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries section in
Safety Precautions bundled with this product.

Feed Mode Switched

When the feed mode is switched during scanning, the [Error] screen on the touch screen displays the following
code.
J7:5F
Check the position of the feed mode switch.
If documents remain in the ADF, remove the documents by referring to
If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries section in
Safety Precautions bundled with this product.

Sensor(s) dirty

If a sensor is dirty, the [Error] screen on the touch screen displays one of the following codes.
J8:01
J8:04
Take the following measures.
● Clean the document sensors by referring to
● Turn the scanner off then back on.
If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries section in
Safety Precautions bundled with this product.
When a Paper Jam Occurs (page
Cleaning the Inside of the Scanner (ADF) with a Cloth (page
146
Troubleshooting
140).
119).