Fujitsu fi-8190 Operator's Manual page 32

No. Name
4 ADF paper chute (feeder)
5 Side guide
6 ADF release tab
7 Operator panel
8 Stack supporter
9 Stacker
10 Stacker extension
11 Stopper
12 Flatbed
13 Transport lock switch
14 Side guide adjuster
Function
Holds the documents to be scanned.
Positions the documents in place when the documents are
loaded in the ADF paper chute (feeder) as they are fed into
the scanner.
Pull this tab to open the ADF.
● For fi-8290/fi-8270
It consists of an LCD and buttons.
Used to operate the scanner or check the status.
For details, refer to How to Use the Operator Panel
[fi-8190/fi-8290/fi-8170/fi-8270] (page
● For fi-8250/fi-8250U
It consists of a Function Number Display, buttons and an
LED indicator.
Used to operate the scanner or check the status.
For details, refer to How to Use the Operator Panel
[fi-8150/fi-8250/fi-8150U/fi-8250U] (page
Supports the ejected documents to be neatly piled up
when it is pulled out.
Stacks up the ejected documents when it is opened
towards you.
Pull it out towards you to adjust the document length.
Lift up to adjust to the document length.
Place documents on the glass section when scanning
documents (such as thin paper or books) that cannot be
scanned with the ADF.
Locks the carrier unit (which is inside the flatbed) to
prevent damage during transportation.
If you use a ballpoint pen to pull out the side guide
adjuster and then attach the ADF paper chute (feeder) to
the scanner, the side guides can be adjusted in accordance
with the width of the document (from 220 mm to 240
mm).
For details, refer to Scanning Documents That Are 220 mm
to 240 mm in Width (page
32
Scanner Overview
138).
172).
178).