Scanning Slowly At Low Resolution [Low-Speed Feed Mode] - Fujitsu fi-8190 Operator's Manual

Scanning Slowly at Low Resolution [Low-speed Feed Mode]

Specify this to slow down the scanning speed in order to protect the documents.
When performing a scan at a low resolution (lower than 400 dpi), the scan is performed at a slow speed regardless
of the resolution that is set. This setting is effective for scanning long page documents.
1
Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page
2
From the list on the left, select [Device Setting 2] → [Low-speed Feed Mode].
3
Select [Enable] if you perform a slow scanning speed in order to protect the documents.
The factory default setting is [Disable].
HINT
For fi-8190/fi-8290/fi-8170/fi-8270, this setting can also be configured in the operator panel.
Scanner Settings (Software Operation Panel)
333).
373