Setting The Shelf Geographical Address; Shelf Manager Replacement Scenarios - Emerson Centellis 2000 Shelf Release 3.0 Manual

8.3.2.1

Setting the Shelf Geographical Address

Set the shelf geographical address during the system installation via a network connection.
The change of shelf address, shelf IP address and FRU activation order takes effect after a
reboot of the system.
Setting the Shelf Geographical Address
To set the shelf geographical address, proceed as follows:
1. Log in to the active shelf manager.
2. Change the shelf geographical address:
# hpishaddr -b "<new shelf geographical address>"
Where <new shelf geographical address> must be two hexadecimal
digits with no leading "0x".
Example: Changing the shelf geographical address to 7:
# hpishaddr -b "07"
3. Reboot the shelf .
You can reboot the shelf mangers via a software reboot without powering OFF and
ON the entire shelf.
The MF106 boards will come up with changed IP addresses.
8.3.2.2

Shelf Manager Replacement Scenarios

This subsection describes different scenarios of replacing the shelf manager and determining
the shelf FRU information.
Replacement during normal operation
If a MF106 is replaced during normal operation, the shelf FRU information on the replaced
MF106 is updated upon insertion. The shelf FRU information remains valid.
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99F)
Network Management and System Access
121