Dc System Startup Procedure - Emerson Centellis 2000 Shelf Release 3.0 Manual

7. Check the AC PSU Status LED and take the appropriate actions as listed in the table
below.
PSU Status LED
LED (red) off
LED (red) on
LED (green) off
LED (red) off
LED (green) on
3.3.3.2

DC System Startup Procedure

Depending on the system configuration, the actual powering up may take up to 3 minutes.
Make sure that the system has been placed in a location at room temperature for at least
24 hours before powering it up.
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack/ESD snap.
3. Mount the grounding cable to the Protective Earth connection lug if not done
already.
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99F)
Status
Reason: The power is disconnected.
Action: Turn off the feed power and attach the power cables at the
power connector .
Power supply is in a failed state.
The power is connected correctly.
System Installation
63