Table of Contents
Advertisement
System Installation
Procedure
To install a system into a standard 19" ANSI rack, proceed as follows:
1. Insert the system into a standard 19" ANSI rack.
2. Fasten the system to the rack via the integrated chassis mounting flanges using two
bolts or screws (minimum 6 mm (0.24 inch) in diameter) on the left side and two
on the right side of the system.
3. Make sure that the system has been placed in a location at room temperature for at
least 24 hours before powering it up.
The following clearances are required when installing the system into an at least 600 mm
(23.62 inch) deep rack. The physical dimensions in the figure below are in millimeters. Make
sure that 60% of the rack's rear is open.
Figure 3-1
58
Rack Mounting Dimensions
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99F)
Advertisement
Table of Contents
