Table of Contents
Advertisement
If the second connecting cable is damaged,
proceed as follows:
1. Replace the connecting cable with connecting
cable
.
49
2. Replace the base of the device (see "7.15 Replac-
ing lower part of housing" on page 41).
7.3 Closing the device
Tools and equipment required:
•
Allen key 3 mm,
•
ESD workplace.
1. Hold the lower part of the housing
the upper part
.
43
2. Push connector
X300
The lug on the connector must be facing the
catch.
3. Push the Western port of the connecting cable
into the guides in the lower part of the
48
housing
.
42
4. Check that all tubes and cables are firmly
connected. If necessary, push them
right onto the stubs (tubes) or auf die connection
points (cables).
5. Align the Powerboard
or Softboard
in the guides inside the
52
53
device.
6. Place the lower part of the housing
upper part
.
43
Make sure that the Powerboard 47 is correctly
fitted and that the connecting cable 48 is not
trapped.
7. Now screw the upper part of the housing tight
using the 2 screws
40
8. Finally, turn the device the right way up.
24
Repair Information and Instructions
against
42
onto the Powerboard
.
47
carefully
and Smartboard
/
47
51
on the
42
and 2 screws
.
41
Smartboard or Softboard
red
42
/
/
51
52
53
47
43
40
Plug for
Smartboard or
Softboard
49
Plug for Power-
board (
)
X1
48
X300
41
Advertisement
Table of Contents
