Checking Display; Checking Pressure And Button Functions - Weinmann SOMNOsmart 2 WM 24900 Manual

5.2.3 Checking display

1. Check that the fascia film of the control panel
is flat all over and firmly in place. If it is not,
5
replace the fascia film (see "7.5 Replacing the
fascia film" on page 26).
2. Now fix up the power supply by connecting
one end of the power cord
the other to the wall socket.
3. Press the On/Off button
appears.
4. Briefly open and close the device outlet port.
The LC display changes.
5. Switch off the device with button
therapy duration appears briefly in the LC
display . Then only "0" is left showing on the
21
LC display .
21

5.2.4 Checking pressure and button functions

1. Assemble the device ready for use with hose
system , mask
12 14
attached.
Note:
If the SOMNOset is in Autotitration or Pressure
Profile mode, switch to APAP or CPAP.
2. With the device switched off, press the
Softstart button repeatedly until the current
26
auto switch-on setting (A0 or A1) appears in the
display.
Note:
if the exhalation relief setting (soft0/soft1/
soft2) appears in the display, first press the
humidifier button
27
switch-on setting.
3. If necessary, press the On/Off button
change the setting to A1.
– The device will now be switched on
automatically as soon as breathing through
the mask starts (pressure > 0.5 hPa),
– When the mask is removed, the device must
switch off after 5 seconds.
4. The day's therapy duration appears briefly in
the LC display . After that, only "0" is left
21
showing on the LC display
5. Press the On/Off button
device on. For 3 seconds the display shows
the total use time
17
6. Close the opening of the mask, e.g. with your
thumb or hand, and hold it closed.
16
Test the device
to the device and
3
. The LC display
24 21
. The day's
24
and power cord
3
to switch to the auto
to
24
.
21
to switch the
24
.
5 21 26 24
21
27
P
ini
21
27 26
SOMNOsoft +
1 hPa
21 27
24
26
25 24
24
1 cmH O
2
26