7.22.3 Set Feature Configuration; Table 7-13 Set Feature Configuration Command - Emerson ATCA-8310 Manual

7.22.3 Set Feature Configuration

This command can be used to enable/disable features within the IPMC during runtime.

Table 7-13 Set Feature Configuration Command

Request Data
Response Data
ATCA-8310 Installation and Use (6806800M72D)
Intelligent Peripheral Management Controller
Byte Data Field
1 LSB of Emerson IANA Enterprise Number. A value of CDh shall
be used.
2 2nd byte of Emerson IANA Enterprise Number. A value of 65h
shall be used.
3 MSB of Emerson IANA Enterprise Number. A value of 00h shall
be used.
4 Feature Selector.
5 Feature Configuration.
00h = disabled (Feature Selector = E0)
01h = enabled (Feature Selector = E0)
02h = restore factory default (golden) (Feature Selector = E1)
C0h = reload selected FPGA image (Feature Selector = E1)
03h - FFh = reserved
6 Persistency / Duration
00h = volatile. Actual duration depends on implementation.
01h - FFh = reserved
1 Completion Code. Generic plus the following command-
specific completion codes:
80h = feature selector not supported.
81h = feature configuration not supported
82h = configuration persistency / duration not supported
2 LSB of Emerson IANA Enterprise Number. A value of CDh shall
be used.
3 2nd byte of Emerson IANA Enterprise Number. A value of 65h
shall be used.
4 MSB of Emerson IANA Enterprise Number. A value of 00h shall
be used.
241