Connectors; Onboard Connectors; Atca Backplane Connectors - Emerson ATCA-8310 Manual

3.1.3

Connectors

The blade provides the following face plate interfaces and control elements:
For GPP:
— Two USB 2.0 ports
— D-SUB15 VGA connector
— Serial console port to connect to either GPP or IPMC serial I/F
— One 1000Base-T Ethernet port
For SPP:
— Serial console port to connect to SPP
— One USB 2.0 port
For IPMI:
— Out of Service, In Service, Attention, and Hot Swap LED's (IPMC control)
— LED's connected to FPGA for BASE IF and Faceplate IF Link Control (FPGA control)
— Recessed reset button
3.2

Onboard Connectors

The blade provides the following on-board connectors:
2x Module Connector for DSP-Mezzanine Card
3.3

ATCA Backplane Connectors

The ATCA specification defines Zone 3 for user input/output signals. On ATCA-8310 ATCA Zone
3 Type A connector (direct connect to RTM) are used. The same connectors are used for Zone
2 and Zone 3. Zone 3 connectors are assigned to reference designators P30 through P32.
Zone 3 Connector P30 is the top most connector. P31 is below P30. P32 is below P31. Zone 3
connectors carry the signals as described in the following tables.
ATCA-8310 Installation and Use (6806800M72D)
Controls, Indicators, and Connectors
59