Emerson ATCA-8310 Manual page 381

Table 8-174 Logic DSP FPGA Register Overview (continued)
0xC2
0xC3
0xC4
0xC5
0xC6
0xC7
0xC8
ATCA-8310 Installation and Use (6806800M72D)
SyncErrMonResReg Synchronization and Error Monitor Reset Register (8bit) [Hw:
syn, WAck1, RAck1]
The bits of this register reset the respective bits in
SyncErrMonReg. Writing a 1 to a bit in SyncErrMonResReg
resets the corresponding bit in SyncErrMonReg. The error bit
in SyncErrMonReg is kept reset until writing a 0 to the
corresponding bit in SyncErrMonResReg reenables its
monitor function.again.
SyncErrMonMaskRe Synchronisation and Error Monitor Mask Register (8bit) [Hw:
g syn, WAck1, RAck1]
The bits of this register mask the bits of the SyncErrMonReg
for the generation of the Host Event Interrupt (HOUT).
DebugLedReg Debug LED Register (8bit) [Hw: syn, WAck1, RAck1]
This register controls the condition of the lower 3 LEDs for
Debug purposes
BaseIdReg Base Board and Module Place Identifier (8bit ) [Hw: syn ,
WAck1, RAck1]
This register shows the status of the base board module place
identifier pins
ModuleFunctionalId Module Functional Identifier (8bit ) [Hw: syn , WAck1 , RAck1]
Reg
This register shows the functional environment version, e.g
board rev
CompResReg Component Reset Register (8bit ) [Hw: syn , WAck1 , RAck1]
The bits of this register reset the respective components, e.g.
Sedes Quad. Writing a 1 to a bit puts the respective
component into reset, until writing a 0 reenables its function
again.
FpgaVersionReg Dsp Fpga Version Register (32bit ) [Hw: syn , WAck1 , RAck1]
This register shows the version of the DspFpga
CPLD and FPGA
381