Initial Connection And Configuration; Establishing A Connection - Emerson Smart Wireless Gateway Quick Start Manual

Quick Start Guide
Step 1: Initial connection and configuration
DeltaV™ ready
If the Gateway was ordered DeltaV Ready (Data Protocols Code 5), then Step 1:
Initial Connection and Configuration is not required. Proceed to Step 2: Physical
Installation, and connect the Gateway to a DeltaV 10.3 or newer control network.

Initial connection and configuration

To configure the Smart Wireless Gateway, a local connection between a
PC/Laptop and the Gateway needs to be established.
Powering the gateway
Bench top power will be needed to power the Gateway by wiring a 24 VDC
(nominal) power source, with at least 250 mA, to the power terminals.
Figure 1. Gateway Terminal Block Diagram
24 VDC
(nominal)
Power Input
+
Case
Ethernet 2
with Power
(Covered)

Establishing a connection

Note
For information on how to connect with a Windows
(document number: 00840-0900-4420).
1. Connect the PC/Laptop to the Ethernet 1 (Primary) receptacle on the
Gateway.
4
Modbus
- S A
Ethernet 2 Ethernet 1
(Secondary) (Primary)
Serial
Not Used
+
B
+
Not Used
®
7 PC, please see the technical note
Not Used
-
S S -
-
S S -
Not Used
April 2013
+
+