Emerson ATCA-8310 Manual page 169

Table 6-3 Variables for Controlling the Boot Progress (continued)
Variable Name
bootdelay
bcm_default_vlan
tftpsilent
srio_ft_deactivate
gpp_max_wait_bios
gpp_max_wait_os
mv_learning_disable
post_disable
vx_info_addr
serverip
ipaddr
gatewayip
ethprime
ethrotate
bootm_low
bootm_size
ATCA-8310 Installation and Use (6806800M72D)
Default Description
10 Delay in seconds before the automatic boot sequence starts.
A value of "-1" disables autoboot.
undefined The default configuration of the ethernet switch.
Default: 0
undefined If set to 1 no hashes (#) are printed when loading images via
network.
undefined If set to 1, no device tree node for the SRIO controllers are created.
Default: 0
undefined Time in micro-seconds. Specifies how long the "gpp start" command
waits for run level updates from the GPP/BIOS (run-level < 10).
Default: 10000000
undefined Time in micro-seconds. Specifies how long the "gpp start" command
waits for run level updates from the GPP/OS (run-level >= 10).
Default: 60000000
undefined If set to 1 MAC address learning for the base interface ports on the
base switch is disabled.
undefined If defined, no POST will be executed.
0x4c00 The address of a data structure evaluated by the Emerson vxWOrks
6.x board support package for the ATCA-8310.
undefined The IP address of the boot server
undefined The IP address used for network communication
undefined The default gateway IP
undefined The default network device to use
undefined If set, network commands will rotate through all available network
interfaces until the operation succeeds
0 The memory start address reported to the OS
undefined Defines the memory size reported to the Linux OS. By default this is
the end of the physical memory. See description of "pram" below.
U-Boot
169