Emerson ATCA-8310 Manual page 380

CPLD and FPGA
Table 8-174 Logic DSP FPGA Register Overview (continued)
DMC Power Supply Control Block (DmcPwrCtrlBlk) [Hw: Cy0]
This Block performs the power sequencing for the DSP power supply. It contains a monitor register
to indicate the voltage
which has caused a potential power supply failure after the DMC has powered up. If one of the power
supplies fails the DMC
is powered down by the DspFpga and the board is informed by the deactivating the DMC_PWRGD
signal.
Access via SPI- bus from GlueFpga (occupies 256 Byte address area), hereof assigned to this block:
B0...BF
Address
0xB0
General Registers (GnrlRegs) [Hw: Cy0]
Collection of general register not dedicated to particular functions
Access via SPI- bus from GlueFpga (occupies 256 Byte address area), hereof assigned to this block:
C0...D7
Address
0xC0
0xC1
380
Acronym Description
DmcPwrMonReg DMC Power Supply Monitor Register (8bit) [Hw: syn, WAck1,
RAck1]
This register monitors power supply failures (power loss and
power interrupt) to identify the power supply which has
caused a power down of the DMC.
Acronym Description
SoftResReg Soft Reset Register (32bit) [Hw: syn, WAck1, RAck1, WTP]
Brings by Soft Reset affected registers to power up state
SyncErrMonReg Synchronization and Error Monitor Register (8bit) [Hw: syn,
WAck1, RAck1]
This register monitors the synchronization and error status of
different functions. If a function signals an out of sync or an
error, the respective bit is set. It can be reset by writing the
respective bit in SyncErrMonResReg
ATCA-8310 Installation and Use (6806800M72D)