Rate Sensor Setup - Raven Command FLEX II Calibration And Operation Manual

Table of Contents

NCV RESPONSE SENSITIVITY

(Not available in NCV Bypass or On/Off control mode) The NCV response sensitivity controls how sensitive the

system is to changes in pressure, flow, and speed. Decrease sensitivity if system pressure and rate oscillate

slightly. Increase sensitivity if control is unresponsive. Avoid setting sensitivity above 70.

STANDBY MODE

Select the desired Standby Mode and Standby Pressure Offset for when the product switch or pump is on, but the

system is not spraying, to maintain a boom or pump pressure in the system for agitation, recirculation, or to

ensure boom pressure does not drop when spraying resumes.

Boom Pressure. System will maintain a target boom pressure. When in Standard or High Flow NCV Control

modes, the target spray pressure value from the home screen will be used as the standby pressure when not

spraying. When in any other control mode, the minimum pressure will be used as the target boom pressure when

not spraying. Any value entered in for Standby Pressure Offset will add to the target pressure, and the system will

maintain that pressure when not spraying.

NOTE:

For example, if the target spray or minimum pressure is 30 psi, and a 5 psi Standby Pressure Offset is

entered, the boom pressure will be maintained at 35 psi when not spraying.

Pump Pressure. System will maintain a target pump pressure. This option is not available if a pump pressure

sensor is not configured. When in Standard or High Flow NCV Control modes, the target spray pressure value

from the home screen will be used as the standby pressure when not spraying. When in any other control mode,

the minimum pressure will be used as the target pump pressure when not spraying. Any value entered in for

Standby Pressure Offset will add to the target pressure, and the system will maintain that pressure when not

spraying.

NOTE:

For example, if the target spray or minimum pressure is 30 psi, and a 5 psi Standby Pressure Offset is

entered, the pump pressure will be maintained at 35 psi when not spraying.

Pump PWM. System will maintain a target pump PWM% when not spraying. This is the default standby mode

when direct injection or boom recirculation are configured on the system. For best results when spraying resumes,

adjust the pump PWM to be no less than the pump PWM readout when actively spraying.

Hold. System will hold the last control valve position or PWM% when not spraying.