Raven Command FLEX II Calibration And Operation Manual page 87

NOTE: If any DTC or of the following Notifications appear and are not expected during normal operation,
follow the listed Recommended Actions.
Type
Activation required
Boom purge in progress
Boom rinse in progress
Diagnostic application control
Fill in progress
Notification
Hardware init error - multiple • Cycle power to system.
Hardware init error - single
Low recirculation flow
Diagnostics: System Diagnostics
Description
• Cycle power to system and check unlocked
• Consult dealer for desired unlock.
• Replace ECU.
• Check tank boom purge status.
• Cycle system power.
• Check tank boom rinse status.
• Cycle system power.
• Go to Tools -> System Settings -> User
• Turn off wireless remote by pressing and
• Cycle power to RCM-S ECU by going to
• Check fill switch position.
• Replace affected NCVs.
• Check for pinched boom supply or
• Check that any sump, master valves, electric
• Check strainers for obstructions. Clean if
• Check that recirculation valve is opening.
• Check for empty product tank.
• Check that pump is on and standby PWM is
• Check that low flow limit is <10 gpm.
• Check for obstructions in strainers, flowmeter,
• Check for correct flowmeter calibration value.
Recommended Actions
features.
Settings -> Wireless Control Mode and set to
"Off."
holding Red 0 button for 3 seconds on
handheld remote.
Diagnostics -> Tests -> Reboot Product
Controller.
recirculation hoses.
boom valves, hand valves, throttling valves,
check valves, and drain valves are open, not
obstructed, or in correct positions.
necessary.
>30.
and check valves.
DIAGNOSTICS
77