Precision Farming Setup Wizard; Ncv Control Mode (Systems With Aim Command Flex™ Ii) - Raven Command FLEX II Calibration And Operation Manual

CHAPTER 4

PRECISION FARMING SETUP WIZARD

Precision Farming Setup offers advanced section settings and features such as section overlap, on/off look-ahead
values, and individual section fore/aft measurements for unconventional boom configurations.
To start the Precision Farming Setup:
UT Menu
RCM - Sprayer Menu
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Applicator Setup tab along the top of the display.
4. Select the Precision Farming Setup button.
NOTE: Some UT displays or task controllers may not be compatible with precision farming settings.
Refer to Chapter 5, Precision Farming Setup, for additional assistance with completing the Precision Farming
Setup Wizard.
NCV CONTROL MODE (SYSTEMS WITH AIM COMMAND FLEX™ II)
NOTE: The NCV Control Mode is only available for RCM - Sprayer with
may only changed outside of an active job. To change modes in the field, the operator will need to
close the job, change the NCV control mode, and then reopen the job.
NOTE: When bypassing
•
NCVs will remain closed.
•
Be sure to open manual shut off valves on each nozzle body and enter the appropriate tip size.
To change the NCV Control Mode:
UT Menu
RCM - Sprayer Menu
NOTE: Section and NCV control modes are also available via the Active Control Mode readout on the home
page. Refer to Readout Descriptions section on page 33 for additional assistance with the available
Display Settings.
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Applicator Setup tab along the top of the display.
4. Use the drop-down list to select the appropriate NCV control mode. Review the RCM - Sprayer Features section
on page 6 for information regarding the available options.
24
Tools Menu
AIM Command FLEX™ II
Tools Menu
RCM - Sprayer and AIM Command FLEX™ II Calibration and Operation Manual
Applicator
Setup
AIM Command FLEX™ II
nozzle control system:
Applicator
Setup
Precision
Farming Setup
systems and
NCV Control
Mode