Chapter 3 System Calibration; Initial Start Up And Calibration Wizard; Transfer Universal Terminals - Raven Command FLEX II Calibration And Operation Manual

CHAPTER
3

INITIAL START UP AND CALIBRATION WIZARD

The calibration wizard must be completed the first time that the system is powered up on the ISOBUS network or
if the default system settings are reset. The calibration wizard allows the operator to quickly configure the Rate
Control Module (RCM) - Sprayer ECU and AIM Command FLEX™ II NCVs if detected.
Review the following sections for assistance with completing the calibration wizard for the AIM Command FLEX™ II
control system.
NOTE: Refer to the UT Operation Manual for other necessary setup or calibration required before operating
the RCM - Sprayer
FIGURE 1. Home Page (Basic Display Mode)
Working Set
Menu

TRANSFER UNIVERSAL TERMINALS

The Transfer UT softkey will be displayed if more than one UT is detected on the ISOBUS. Use
this button to switch the RCM - Sprayer working set menu to an alternate UT at any time.
System Calibration: Initial Start Up and Calibration Wizard
S YSTEM CALIBRATION
C H A P T E R 3
control system or features.
RCM - Sprayer Home Page
Quick Access
Softkeys
Transfer UT
11