Table of Contents
Advertisement
MPA Hub Mount I&O Manual
Note: These Power Supply trip parameters are preset at the factory and
should not be changed except during parts replacement service by
factory trained technicians.
Miscellaneous Screen
This screen shows the software version and allows the user to select the
amplifier type and switch system type (if equipped with internal switch
controller option).
Figure B-7 Miscellaneous screen
Letter Function keys
The letter function keys are shown in the lower right hand corner on all
screens except the startup screen. Pressing these letters on the keyboard will
perform the corresponding action (Transmit, Standby, Reset and Inhibit).
The Inhibit (I) key is used for RF inhibit in both standby and transmit states.
When this key is pressed the message (upper left corner in blue) will tell the
used that the amplifier is in the "RF Inhibit" state as shown in Figure B-8.
Pressing this key again will return the MPA to "non Inhibited" state and the
message will disappear.
Setup & remote control software B-5
Doc. 01031254 Rev. 1
Advertisement
Table of Contents
