About This Manual - CPI T04CO Installation & Operation Manual

1.3 About This Manual

This manual describes the MPA Hub Mount installation and
operation procedures.
The Safety section that precedes Chapter 1 provides practical
guidelines regarding High Voltage and Microwave Radiation
operating practices.
Chapter 2, "Unpacking and installation", contains procedures for
unpacking and installing MPA Hub Mount.
Chapter 3, "Initial Power ON and Checkout", describes the controls
and indicators on the front panel of the amplifier, the CPI Remote
Control Unit controls and indicators, and the procedures to use for
initial checkout after the amplifier has been installed.
Chapter 4, "Interfaces", describes:
•
•
Chapter 5, "Operation", describes the procedures for normal start-
up and shutdown, and describes the operational modes of the
amplifier.
Chapter 6, "Maintenance", describes the procedures for scheduled
maintenance and the procedures for return of equipment to CPI.
Chapter 7, "Drawings", contains relevant engineering drawings
and specifications of the Hub Mount Low Power Amplifier.
The Appendices, "A" through "G", contain additional topics such
as "Service and Warranty" information and optional features.
1-4
The Hub Mount Medium Power Amplifier external interfaces
and external connector pinouts.
The commands used to setup the serial interface hardware
characteristics.
I N T R O D U C T I O N
Installation and Operation Manual