Table of Contents
Advertisement
2.4.5
Switch Interface Connector (J5)
Connector J5 is a round 26-pin female (socket) connector that is
used for redundant system operation.
NOTE: A mating, wired connector (jumper plug) is supplied with the
unit. If the amplifier is to be used in a standalone configuration, this
connector must be used.
2.4.6
RF Coaxial Cable Connections (J3, J4)
Refer back to Figure 2-1 for connector locations. Prepare a user
supplied coaxial cable and connect this RF drive cable to RF Input
connector J3. A power monitor cable can be connected directly to
front panel connector J4 (40 dB nominal coupling). Tighten the
connector(s).
CAUTION! Position the coaxial cables so that there is no stress on
connectors J3 or J4.
Doc. 01031254 Rev. 1
M P A H U B M O U N T
2-7
Advertisement
Table of Contents
