Table of Contents
Advertisement
2.4.2
Cooling Considerations
The MPA Hub Mount is forced air-cooled by an internal fan which
draws air into the bottom of the unit. The air is exhausted through
ducts located on the front panel. Refer to outline drawing.
To insure proper operation of the amplifier, the following
guidelines must be observed:
• There must be at least two inches of clearance on the bottom of
• There must be at least three inches of clearance on the end of the
• The hot exhaust air must be directed away from the air intake
• The area below the air intake must be free of foreign material,
Doc. 01031254 Rev. 1
the unit (air intake).
unit that has the exhaust ducts (the end with the visible cooling
fins).
area.
loose dirt, debris, and any other material that may be drawn
toward the unit and block the air intake area.
M P A H U B M O U N T
2-3
Advertisement
Table of Contents
