Table 4-1. Rf Switch Pin Assignment (J5) - CPI T04CO Installation & Operation Manual

Table 4-1. RF Switch Pin Assignment (J5)

Pin # Signal Name
A Status Relay 1 NO
B Status Relay 1 NC
C Status Relay 1 COM
D Status Relay 2 NO
E Status Relay 2 NC
F Status Relay 2 COM
G External Latching I/L
H External Latching I/L Rtn
J External Non-Latching I/L
K Ext. Non-latch I/L Rtn
L RF Inhibit
M RF Inhibit Rtn
N Reset to Defaults
P Reset to Defaults Rtn
R WG SW POS 1 OUT
S WG SW GND
T WG SW POS 2 OUT
U WG SW POS 1 IN
V WG SW GND
W WG SW POS 2 IN
X FAULT
Y GND
4-6
Remarks
Relay 1 normally-open contact. Function defined by
switch S1.
Relay 1 normally-closed contact. Function defined by
switch S1.
Relay 1 common contact.
Relay 2 normally-open contact. Function defined by
switch S1.
Relay 2 normally-closed contact. Function defined by
switch S1.
Relay 2 common contact.
Open from Return (pin H) for latching Beam Off
interlock.
Latching interlock return.
Open from Return (pin K) for non-latching (RF Inhibit)
Interlock.
Non-Latching interlock Return.
Open from Return (pin M) for non-latching RF Inhibit.
RF Inhibit Return.
Shorting this to return (pin P) while unit is turned on will
reset the serial communication parameters to the
factory defaults.
Reset Return.
Drive to Waveguide Switch for position 1
Waveguide Switch Drive Return
Drive to Waveguide Switch for position 2
Contact indicating Waveguide Switch position 1
Waveguide Switch position return
Contact indicating Waveguide Switch position 2
Fault relay from other amplifier
Digital Ground
E X T E R N A L I N T E R F A C E S
Installation and Operation Manual