Table of Contents
Advertisement
2.4 Installation
Installation of the MPA Hub Mount includes:
• Mechanical installation
• Electrical power connections
• Remote control interface
• RF connections
2.4.1
Amplifier Installation
Refer to the appropriate Outline Drawing in Chapter 7 "Drawings"
for outline and mounting information.
The amplifier may be mounted using the six tapped holes located
on the side (refer to the Outline Drawing). These holes are 10-32
UNC-2B thread and are 0.38 inch deep. In order to provide secure
mounting, screws with locking hardware must be used in all six
holes.
If the amplifier is mounted to an antenna, the structure must be
capable of supporting the additional load of the amplifier plus any
wind loading effects which may occur. It is recommended that
locations subject to electrical interference, such as that from motor
contactors, be avoided.
The amplifier is air-cooled. The intake and exhaust areas must not
be blocked. See the outline drawing for further information.
2-2
I N S T A L L A T I O N
Installation and Operation Manual
Advertisement
Table of Contents
