Table of Contents
Advertisement
3.8
Setup for Operational Service
Before committing the amplifier to operational service, you can set
the amplifier operating and interface parameters (for computer
controlled operations).
If computer controlled operation is desired, refer to Chapter 4 to
select the desired interface configuration and to drawings in
chapter 7 for CIF protocol document.
If the optional Remote Control Panel is to be used, the interface
parameters do not require adjustment. To change operational
parameters via the Remote Control Panel, use the procedure below
to change selected parameters:
a
b
The unit is ready for operational service.
Doc. 01031254 Rev. 1
Press FUNCTION until the option for the desired parameter is
displayed.
Use the
keys to change the parameter to the desired
value and press ENTER to accept the new value.
M P A H U B M O U N T
3-17
Advertisement
Table of Contents
