Figure B-4 Communication Settings - CPI T04CO Installation & Operation Manual

MPA Hub Mount I&O Manual
If this fault screen appears, check to see that the MPA is properly connected
to the computer and that the communication settings have not changed.
The communication settings for the remote software are shown in Figure B-4.

Figure B-4 Communication settings

If the user has changed the MPA comm. settings, then the settings under the
CIF tab (Figure B-4) must be changed to match. Also check to see that the Port
setting matches the port you are connected to on your computer.
To change the CIF settings, use the up/down arrow keys to select the setting
and press F1 (scroll data). Now use the up/down keys to change each setting
followed by F1 to save each setting.
RF Control Tab
Use the left/right arrow keys to select the RF control tab (see Figure B-5).
These are the RF system parameter and trip settings.
You can now use the up/down arrow keys and the F1 key to change RF
system parameters and trip settings.
Setup & remote control software B-3
Doc. 01031254 Rev. 1