Figure B-1 Startup Screen - CPI T04CO Installation & Operation Manual

MPA Hub Mount I&O Manual
Appendix B
Setup & Remote Control Software
This Appendix describes operation of the Hub Mount MPA with the CPI
supplied "Setup & Remote Control Software".
The program (remote.exe) is supplied along with this manual on a single
floppy disk and will run in DOS mode on any IBM compatible PC. To install
the program, simply copy it (remote.exe) to your local disk drive or run the
program directly from the supplied floppy.
Starting the program
Make sure the MPA is connected via either an RS232 or RS422/485 cable to
the computer. See chapter 2 for more information.
To run the program, either create an icon (in windows mode) or type in the
command "remote.exe" at the dos prompt (in the directory the program was
installed).
The startup CPI screen will appear as shown in figure B-1.

Figure B-1 Startup screen

Setup & remote control software B-1
Doc. 01031254 Rev. 1