Table of Contents
Advertisement
NORMAL OPERATION
5.1 General
The REMOTE mode is the control mode for normal operation of the
amplifier. In this mode, the full set of monitoring and control
functions are available to the remote control device. For remote
control operations, the user has the choice of:
• Remote Control via a CPI Remote Control Unit or
• Remote Control via an IBM PC compatible computer with CPI
NOTE: Only one remote control device can be connected to the
amplifer (to connector J6) at one time.
If the amplifier has been set up for normal operation and the
remote control device is temporarily unavailable, the amplifier can
be set for operational service in the LOCAL mode until the remote
capability is restored for operational service.
Control commands from the remote control device that affect the
operating status of the amplifier, such as TRANSMIT or STANDBY,
are accepted only when the amplifier is set for the REMOTE control
mode.
The Remote Control Unit Menu tree is shown in Figure 3-5.
Doc. 01031254 Rev. 1
Chapter 5
supplied Remote Control Software or custom monitor and
control equipment developed & supplied by the user.
M P A H U B M O U N T
5-1
Advertisement
Table of Contents
