Table of Contents
Advertisement
4.3.1
Relay Definitions
Each of the two status relays can be programmed to indicate one of
several conditions. The configuration of these relays is controlled
through the computer interface (CIF) port. The provided Remote &
Setup control software allows control of this configuration on the
RF control tab. See Appendix B, figure B-5.
Doc. 01031254 Rev. 1
NOTE: If the RF Switch Interface is not used, it must be
terminated with a mating connector (supplied in the ship kit) wired
as follows: jumper pin G to pin H, pin J to pin K, and pin L to pin M.
M P A H U B M O U N T
4-3
Advertisement
Table of Contents
