Table of Contents
Advertisement
Default settings are as follows: STX/ETX protocol, 9600 baud rate,
even parity, seven (7) data bits, with one (1) start bit and one (1)
stop bit. The operator may change these settings. Refer to
Drawings (chapter 7) for the Computer interface protocol
document.
Interconnect cables should be wired for either RS-232 or
RS-422/485, but not both. A cable assembly similar to CPI drawing
#01026580 (see Chapter 7) should be used for RS-422/485
communication. A wiring diagram for a cable using RS-232 is
shown in Figure 2-2.
ITT Cannon
p/n KPSE06F12-10P
(Mates with J6)
ITT Cannon
p/n KPSE06F12-10P
(Mates with J6)
2-6
F
G
H
RS-232 Interface Cable for 9-pin "D" Connector
F
G
H
RS-232 Interface Cable for 25-pin "D" Connector
I N S T A L L A T I O N
2
9-pin "D" Connector
3
(Female)
5
3
25-pin "D" Connector
2
(Female)
7
Figure 2-2. RS-232 Cables
Installation and Operation Manual
Advertisement
Table of Contents
