Table of Contents
Advertisement
3.3.3
Display and LED Group
Refer to Figure 3-4 for the Display and LED Group details.
TRANSMIT
Single Line Display
20 Characters
GREEN
YELLOW
The menu tree shown in Figure 3-5 identifies the display messages
associated with each of the Remote Control Unit display modes.
When the Main Menu is displayed, the first part of the display
indicates the current control point set by the LOCAL/REMOTE
switch.
Seven sets of messages are possible when the Main Menu is
selected. Normally, one of the messages shown directly below the
Main Menu box in Figure 3-5 is displayed. If an ALARM condition
exists, one of the messages shown below the ALARM CONDITION
box is displayed. If a FAULT CONDITION exists, one of the
messages shown below the FAULT CONDITION box is displayed.
Press the METERS key to access the METERS menu. Press the
METERS key repeatedly to scroll through the seven messages
shown in Figure 3-5. Pressing this key an eighth time returns the
display to the MAIN MENU.
3-8
STANDBY
FAULT
REMOTE
AUTO
ONLINE
LOCAL RF OUT 127W
TRANSMIT
STANDBY
FAULT
RED
YELLOW
I N I T I A L P O W E R - O N A N D C H E C K O U T
TRANSMIT
FUNCTION
STANDBY
METERS
Display and LEDs
REMOTE
AUTO
GREEN
GREEN
Figure 3-4. Display and LED Group
Installation and Operation Manual
RESET
AUTO/MAN
ENTER
SWITCH
ONLINE
Advertisement
Table of Contents
