On Line Mode; Key Function; Online Mode Display - Toshiba B-EX4 Series Maintenance Manual

6. ON LINE MODE

6. ON LINE MODE

6.1 KEY FUNCTION

The printer behaviour is not guaranteed when undefined key is operated.
6.1.1

Online Mode Display

Key Function
[FEED] (1) Feeds one piece of media.
(2) Prints the data in the image buffer on one piece of media according to the
* For details of the following cases, refer to the parameter setting section.
* In the strip mode, feeds labels even when the peel-off sensor is detecting a label.
* When Media Load parameter is enabled, a media feed is performed to find the print
start position depending on the condition. For details, refer to Section 8.4.1.1 MEDIA
LOAD.
[RESTART] (1) Resumes printing after a temporary stop of printing or after an error.
(2) Places the printer in the usual initial state, which is obtained when the power is
(3) Places the printer in the user system mode.
[PAUSE] (1) Stops label printing temporarily.
(2) Programs the threshold value.
[MODE] (1) Places the printer in the user system mode.
[CANCEL] (1) Clears the job.
[ENTER] (1) Displays help messages.
(2) Saves the log/receive buffer data.
(3) Places the printer in the RFID calibration mode.
[UP] (1) Places the printer in the Information mode.
(Supported from the firmware version C1.0I for B-EX4T1-G/T-QM/CN, C1.0F for the B-EX4T2-G/T-
QM/CN, C1.1A for the B-EX4T2-H-QM/CN, and D1.1 for the B-EX4D2-G/T-QM/CN.)
[DOWN] (1) No function.
[LEFT] (1) No function.
[RIGHT] (1) Displays help messages.
Ejects one piece of media.
Used to adjust the media to the proper position. If printing is attempted with the
media improperly positioned, printing is not performed at the proper position.
One or two pieces of media need to be fed to adjust the paper position before
printing.
system mode setting.
NOTE: A Clear Command or a command for drawing shall not be sent while
printing caused by a depression of the [FEED] key. If it is sent, the layout will be
destroyed, and the media will not be printed properly. Also, if printing is
performed by a depression of the [FEED] key while the data is being drawn in the
image buffer, the layout may be destroyed.
• How to issue the label stock having the label pitch of 25.4 mm or less in the cut
issue mode when the disc cutter is used.
• How to issue the label stock having the minimum label pitch or less for each print
speed in the cut issue mode when the rotary cutter is used.
turned on.
(
Supported by the B-EX4T1-G/T-QM/CN C1.4 or later).
(B-EX4T1 Japan model with firmware V1.0I only)
6-1
EO18-33027
6.1 KEY FUNCTION