Toshiba B-EX4 Series Maintenance Manual page 128

5. SYSTEM MODE
5.4.1.3 FORWARD WAIT POS.
Max. Min. value
value
5.0 -5.0
・ + (Plus)
・ - (Minus)
NOTES:
1. If the pitch of the media used for the previous issue was less than 20mm, the forward wait will not be
activated regardless of the parameter setting
<Supplement> In the case labels with the different pitch (less than 20mm and 20mm or longer) are
alternately placed in one label roll, the forward wait is not activated for the labels with the pitch of
less than 20mm. Therefore it stays at the print stop position without being fed backward. Before the
next label with the pitch of 20mm or larger is printed, however, it is automatically fed backward along
with the previously printed label. This may cause the print data to be printed on the previous label.
2. The media will stay at the forwarded position even if the power is turned off/on, the printer is reset,
or the print head is opened/closed.
5.4.1.4 FW/BK ACT.
・ MODE1
・ MODE2
・ MODE3
Step Display
0.1 Decimal
Increases the forward feed amount.
Decreases the forward feed amount.
The printer waits for a next issue after 13.7-mm media is forwarded.
When the thermal transfer method and cut issue are selected, the printer feeds 6-
mm media backward, then waits for next issue with 3-mm media forwarded.
The printer waits for a next issued after 31.2-mm media is forwarded (to prevent
RFID media jam.) MODE3 is exclusively for issuing RFID media.
NOTES:
1. Before the printer starts printing (feed), it feeds the media for 3 mm from this
position and temporarily stops. The feed speed for this 3-mm distance to the
home position is the max. speed that can be accelerated from the previous
speed (See the following). After the temporary stop, the printer prints or feeds
the media at the specified speed.
203-dpi/600-dpi model: 6 ips
300-dpi/305-dpi model: 5 ips
* Except for the multi-step acceleration area for short-pitch labels, the print speed
will be accelerated up to the specified speed when the media has not been
forwarded.
2. When MODE3 is selected and the RBN SAVE parameter is set to "LABEL" or
"TAG", the printer will raise the print head while the auto forward feed function is
performed.
If labels with the pitch of 57.2mm or less are used, they may be removed from
the backing paper. Therefore, it is required to select "LABEL" or "TAG" for the
RBN SAVE parameter. The speed of the auto forward feed is fixed to 3 ips.
This feature is supported by B-EX4T1-G/T-QM/CN C1.2 or later and B-EX4T1-
TS25-R V2.1 or later.
Sign Integer Decimal
digit
Exist 2
5-32
5.4 PARAMETER SET
0-padding
place measure
1 None
EO18-33027
Unit of
mm