Toshiba B-EX4 Series Maintenance Manual page 155

5. SYSTEM MODE
Print density fine adjustment ................................................. -20 step to ±10 step
X-coordinate fine adjustment ................................................................ ±99.5 mm
Ribbon motor drive voltage fine adjustment (Take-up) ................. -15 to +10 step
Ribbon motor drive voltage fine adjustment (Back tension) ......... -15 to +10 step
• The X-coordinate fine adjustment is performed to fine adjust the X-coordinate of the drawing in the left or
right direction.
coordinate "0", the value remains unchanged even if a subsequent fine adjustment is performed in the
negative direction.)
• The X-coordinate fine adjustment is not effective for the self-test results printout (maintenance counter,
various parameters, and automatic self-test) and the test print.
• The print density fine adjustment value is +0 step at the time of shipment from the factory.
• The ribbon take-up/back tension motors drive voltage fine adjustment values are the sum of the fine
adjustment by the command (from the PC) and the fine adjustment in the system mode (by key
operation). The range of fine adjustment is from –15 to +10 for both the ribbon take-up motor and the
ribbon back tension motor.
• The print density fine adjustment value is the sum of the fine adjustment by command (from the PC) and
the fine adjustment in the system mode (by key operation). The respective max. Fine adjustment values
are –20 to +10. The max value for each print speed is as below. When the value exceeds the maximum,
it is automatically corrected to the max value.
[Both direct thermal and thermal transfer]
Speed 203 dpi
2 ips
3 ips
4 ips
5 ips
6 ips
8 ips
10 ips
12 ips
14 ips
5.5.11 HDDWNADJ
This is the function to fine adjust the head-down timing.
Fine adjustment of the head-down timing is required to be performed with @080 command, not through key
operations on the printer. (For the @008 command, refer to External Equipment Interface Specification for the B-
EX Series.)
The factory default is 0 msec., and the adjustment value will not be initialized by a RAM clear.
* This function is supported from the firmware version of V2.0B for the B-EX4T1-TS25-R.
Adjust the X-coordinate in the effective print range.
B-EX4T1
305 dpi 203 dpi
+10 +10 +10
+10
+10 +10
+10
+10 +10 +10
+10 +10 +10
+10 +10
B-EX4T2
300 dpi 600 dpi 203 dpi
+10
+10 +10
+10
+10 +10
+10
+10
+10
+10
5-59
(After the value reaches the
B-EX6T2 B-EX4D2
300 dpi 203 dpi
+10 +10 +10
+10
+10 +10
+10
+10 +10 +10
+10
EO18-33027
5.5 ADJUST SET
300 dpi
+10
+10
+10
+10
+10