Toshiba B-EX4 Series Maintenance Manual page 135

5. SYSTEM MODE
5.4.2.14 RBN END
・ TYPE1
・ TYPE2
TYPE1:
When a label end or ribbon end is detected in the middle of printing, printing is immediately stopped.
When the printing is restarted, first the initial feed is performed, then the printer starts printing from the
unfinished label.
TYPE2:
TYPE 2 is available only when the ribbon saving function is set to OFF. When the ribbon saving is
enabled, TYPE 1 will be automatically performed regardless of the selection.
[Label end]
When a label end is detected in the middle of printing, the printer completes the half-finished label and
stops when the next label is at the home position, displaying the error message "NO PAPER
indicates the remaining number of labels.) The remaining number of labels = [Specified number of
labels] − [The number of finished labels including half-finished one]
If a label end is detected while the specified last label is printed, the position of "X" will be blank.
When the printing is restarted, first the initial feed is performed, and then the printer starts printing
from the next label. In case of the label end while the specified last label is printed, only the initial
feed is performed, and if the status response is set to ON, an issue end status is sent following a feed
end status.
[Ribbon end]
When a ribbon end is detected when the unfinished label length is 30 mm or more, printer prints for 20
mm and stops printing, displaying an error message "NO RIBBON
number of labels.)
The remaining number labels = [Specified number of labels] − [The number of finished labels] − 1
If a ribbon end is detected while the specified last label is printed, the position of "X" will be blank.
When the printing is restarted, first the initial feed is performed, and then the printer starts printing
from the next label. In case of the ribbon end while the specified last label is printed, only the initial
feed is performed.
When a label end or ribbon end status is detected, the printer stops immediately.
When a label end or ribbon end status is detected, the printer prints the current label as far
as possible, then stops.
5-39
5.4 PARAMETER SET
X". ("X" indicates the remaining
EO18-33027
X". ("X"