Toshiba B-EX4 Series Maintenance Manual page 145

5. SYSTEM MODE
5.5.2 CUT ADJ
Max. Min. value
value
50.0 -50.0
[Procedure for label having label pitch of less than 25.4 mm when the disc cutter is used]
The minimum label pitch of the label which can be cut in normal use is 25.4 mm. When a label
having a label pitch of less than 25.4 mm is used (although it is out of specifications), the edge of the
label is caught by the edge of the thermal head during a back feed to the home position after cutting
the gap area between labels. Therefore, the label may not be fed back to the proper home position.
By performing either method below, the problem will be solved.
[Method 1] Lift the head.
Step Display
0.1 Decimal
+0.0 mm
+3.0 mm
-3.0 mm
Paper feed direction
When the following conditions are all met, the cut operation is as follows.
Head lifted → Forward feed to the cut position → Head lowered → Cut →
Head lifted → Reverse feed to the home position → Head lowered
Conditions: Issue Command, Feed Command, and Eject Command received.
Label pitch of 25.4 mm or less, cut performed, transmissive sensor
designated, cut position fine adjustment of ±10.0 mm or less, and issue
mode "C"
* The head is lifted/lowered only when the optional ribbon saving module is mounted
and the ribbon saving function is set to ON with the parameter setting menu. When
the ribbon saving module is not installed, use Method 2 since the print head is not
lifted/lowered.
Sign Integer Decimal
digit
Exist 2
Cut position
Cut position
Cut position
5-49
5.5 ADJUST SET
0-padding
place measure
1 None
EO18-33027
Unit of
mm