Toshiba B-EX4 Series Maintenance Manual page 129

5. SYSTEM MODE
5.4.1.5 HU CUT/RWD.
Whether or not to activate the head up action in the cut issue or to use the Rewinder in the batch or
strip issue is selected.
* The print head may not be raised depending on the rise of the solenoid's temperature.
・ OFF
・ ON
NOTE: Since the head-up function is not available to the B-EX4T2, B-EX6T2, and B-EX4D2, this
parameter is to choose whether to use the Rewinder or not. The head-up operation is fixed to
OFF.
5.4.1.6 RBN SAVE
・ TAG
・ LABEL
・ OFF
(NOTE3):
・ TAG2
(NOTE3):
・ LABEL2
NOTES:
1. If this parameter is set to "Enabled" without the ribbon saving module not installed, the ribbon
slacks and a print failure occurs. Care must be taken when setting this parameter.
Also, the ribbon saving option shall be selected depending on the head lever position. Incorrect
setting may disable the proper ribbon saving function.
2. Even if the "TAG" or LABEL" is selected for the B-EX4T2, B-EX6T2, or B-EX4D2, the setting and
the printer behavior will be automatically changed to "OFF" because the head-up function is not
available to these models.
3. TAG2 and LABEL2 are supported only by the B-EX4T1-TS25-R V2.0 or later. The difference
between "ON:TAG" and "ON:TAG2", and between "ON:LBL" and "ON:LBL2", respectively, is the
distance of non-print area where a ribbon save is performed. (In the case of 8 ips or faster)
5.4.1.7 PRE PEEL OFF
・ OFF
・ ON
NOTE:
Pre peel off is automatically enabled when the print speed is set to 10 ips or faster for the strip issue.
However, the print speed is corrected depending on the EX I/O parameter setting, as follows.
▪ EXI/O: TYPE 1 (Standard)
203-dpi model: 10 ips
300-dpi/305-dpi model: 8 ips
▪ EX I/O: TYPE 2 (Inline)
Specified speed
Accordingly, when the print speed is set to 8 ips or less, pre peel off is enabled only when this
Head up cut is not performed or the Rewinder is not used.
Head up cut is performed or the Rewinder is used.
Enabled (When the head lever is set to TAG position)
Enabled (When the head lever is set to Label position)
Disabled.
Enabled (When the head lever is set to TAG position)
: Enabled (When the head lever is set to Label position)
Disables pre peel off
Enables pre peel off
5-33
EO18-33027
5.4 PARAMETER SET