Toshiba B-EX4 Series Maintenance Manual page 148

5. SYSTEM MODE
[Procedure for label having less than the min. label pitch for each issue speed when the rotary cutter
is used]
When the following conditions are all met, the cut operation for the last label to be cut is as follows.
Forward feed to the cut position → Cut while feeding → Feed stops →
Head lifted → Reverse feed to the home position → Head lowered
Conditions: Issue Command, Feed Command, and Eject Command received.
Label pitch: Less than the min. label pitch for each issue speed,
cut performed, transmissive sensor designated, cut position fine adjustment
of ±10.0 mm or less, and issue mode "C"
* For the Issue Command, this procedure is effective only when the next Issue
Command is not received at the last label to be cut.
* The print head is lifted/lowered only when the optional ribbon saving module is
mounted and the ribbon saving function is set to ON with the parameter setting menu.
When the ribbon saving module is not installed, the print head is not lifted or lowered.
NOTES: 1. If the bottom edge of the last label advances past the feed roller while the
print head is lifted during label feed to cut, the sensor may not be able to
detect an error even if the label cannot be fed any more.
2. If the head-up solenoid temperature is high when a cut issue is about to
be performed with the head lifted, the head may not be lifted .
5-52
EO18-33027
5.5 ADJUST SET