Toshiba B-EX4 Series Maintenance Manual page 162

5. SYSTEM MODE
5.6.8 AUTO PRINT (TRANS.)
The factory test print is performed on the following conditions. The parameter settings and the print
density fine adjustment value are ignored.
After each test pattern is printed, the factory test print is performed when the [ENTER] key (or its
•
compatible key) is pressed.
When the [CANCEL] key (or its compatible key) is pressed, the display returns to the menu.
•
Other keys are invalid.
•
Print test pattern
Issue count
Print speed
Sensor type
Print method
Issue mode
Label pitch
Print density fine adjustment value
5.6.9 AUTO PRINT (REFL.)
The factory test print is performed on the following conditions. The parameter settings and the print
density fine adjustment value are ignored.
After each test pattern is printed, the factory test print is performed when the [ENTER] key (or its
•
compatible key) is pressed.
When the [CANCEL] key (or its compatible key) is pressed, the display returns to the menu.
•
Other keys are invalid.
•
Print test pattern
Issue piece5 pieces each
Print speed
Sensor type
Print method
Issue type
Label pitch
Print density fine adjustment value
Feeding 1 label
Printing 3-dot slant lines
Printing barcode
Printing characters
5 labels each
6"/sec.
B-EX4T1-G, B-EX4T2-G, B-EX6T2-G, B-EX4D2-G
5"/sec.
B-EX4T1-T, B-EX4T2-T, B-EX6T2-T, B-EX4D2-T
3"/sec.
B-EX4T2-H
Transmissive sensor
B-EX4T1/EX4T2/EX6T2: Thermal transfer
B-EX4D2: Direct thermal
Continuous issue
76 mm
±0
Feeding 1 label
Printing 3-dot slant lines
Printing barcode
Printing characters
5 labels each
6"/sec.
B-EX4T1-G, B-EX4T2-G, B-EX6T2-G, B-EX4D2-G
5"/sec.
B-EX4T1-T, B-EX4T2-T, B-EX6T2-T, B-EX4D2-T
(600 dpi)
B-EX4T2-H: 3"/sec.
Transmissive sensor
B-EX4T1/EX4T2/EX6T2: Thermal transfer
B-EX4D2: Direct thermal
Continuous issue
76 mm
±0
5-66
EO18-33027
5.6 TEST PRINT