4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
12. Attach the Cutter Cover to the Cutter Unit with the Plastic Head Screws.
13. Restore the Platen Holder Cover.
NOTE: The strip plate is not used. Keep it safe for future use.
14. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the
print head block or damage to the print head.
Plastic Head Screw
Cutter Unit
Platen Holder Cover
Cutter Cover
4- 7
EO18-33027
(Revised on OCT. 2013)
4.1 DISC CUTTER (B-EX204-QM-R)