Toshiba B-EX4 Series Maintenance Manual page 154

5. SYSTEM MODE
-1
-2
5.5.8.1 TYPE1
Max. Min. value
value
10 -15
The fine adjustment value is not effective for the reverse rotation.
All fine adjustment values are applicable to every print speed.
5.5.8.2 TYPE2
Max. Min. value
value
10 -15
The fine adjustment value is not effective for the reverse rotation.
All fine adjustment values are applicable to every print speed.
5.5.9 THRESHOLD <REFL.>
Max. Min. value
value
4.0 0.0
NOTE: If "0.0 V" is set, the value "0.0 V" is returned to the initial value (1.0 V) when the power is turned
OFF then ON.
5.5.10 THRESHOLD <TRANS.>
Max. Min. value
value
4.0 0.0
NOTE: If "0.0 V" is set, the value "0.0 V" is returned to the initial value (1.4 V) when the power is turned
OFF then ON.
Supplementary explanation
• When the [RESTART] and [FEED] keys are pressed at the same time, the display returns to the system
mode menu.
• When the [RESTART] or [FEED] key is held down for 0.5 seconds or more when a fine adjustment value
is being set, the printer enters the repeat mode, in which the key is entered repeatedly.
• A changed fine adjustment value is stored in memory by pressing the [PAUSE] key.
• The printer is controlled by the sum of the fine adjustment parameter programmed on the printer and the
fine adjustment command from the PC. However, the maximum values for each fine adjustment are as
follows:
Feed fine adjustment ............................................................................. ±50.0 mm
Strip position fine adjustment ................................................................ ±50.0 mm
Back feed fine adjustment ....................................................................... ±9.9 mm
82%
79%
Step Display
1 Decimal
Step Display
1 Decimal
Step Display
0.1 Decimal
Step Display
0.1 Decimal
-14
-15
Sign Integer Decimal
digit
Exist 2
Sign Integer Decimal
digit
Exist 2
Sign Integer Decimal
digit
None 1
Sign Integer Decimal
digit
None 1
5-58
5.5 ADJUST SET
43%
40%
0-padding
place measure
0 None
0-padding
place measure
0 None
0-padding
place measure
1 None
0-padding
place measure
1 None
EO18-33027
Unit of
Step
Unit of
Step
Unit of
V
Unit of
V