Toshiba B-EX4 Series Maintenance Manual page 193

5. SYSTEM MODE
Max. Min. value
value
+999.9 -999.9
By performing an RFID calibration, an optimum data read/write position (distance from the home
position) is automatically obtained and set. This parameter is effective only when the CALIB. MODE
parameter is set to ON.
The printer will automatically feed RFID media forward/backward for the distance specified by CALIB.
POSITION parameter before writing/reading RFID tag, which is normally performed with @003
command.
The feed direction is indicated by "+" (backward) and "−" (forward). Setting values ranging from -
2.9mm to +2.9mm do not affect the read/write position fine adjustment.
Applicable model: B-EX4T1-G/T-QM/CN C1.4 or later.
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
・ FRONT ... Reserved
・ CENTER ... Reserved
・ REAR
This parameter, used for an RFID calibration, is to select the combinational position of the RF antenna
and the wave director. A "usable" antenna position must be selected for this parameter. Otherwise,
the printer operation is not guaranteed. (Refer to Section 6.7.1 Outline of the RFID Calibration.)
This function is supported by the B-EX4T1-G/T C1.4 or later.
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
Antenna position
FRONT
CENTER
REAR
5.11.4.8 CALIB. POSITION
Step Display
0.1 Decimal
5.11.4.9 ANTENNA POSITION
Antenna rotation
0°
Sign Integer Decimal
digit
None 3
Wave director position
0 mm
5-97
5.11 RFID Module Setting
0-padding
place measure
1 None
Application
Usable
Unusable
Unusable
EO18-33027
Unit of
mm