Outline Of Each Mode; Online Mode; Threshold Setting Mode; Rfid Calibration Mode - Toshiba B-EX4T1 Series Owner's Manual

2.PRINTER SETUP

2.6 OUTLINE OF EACH MODE

This chapter describes the outline of each mode supported by the printer. Refer to each chapter for detailed
information.

2.6.1 ONLINE MODE

This mode is mainly used by users (operators).
The label or tag can be issued in the online mode. When an error occurs, the help function shows the
cause of the error, troubleshooting, and recovery from the error. The threshold setting, described below,
is also a part of the online mode.

2.6.2 Threshold setting mode

Threshold setting mode is provided to correct a print failure with pre-printed media.
When using pre-print label, print start positions may not be detected correctly with the usual media sensor
threshold, depending on the ink type. Such error can be prevented by setting the threshold just for the pre-
printed media to be used. Since the threshold setting value is stored in the non-volatile memory, it is
unnecessary to set the threshold again as long as the same pre-print media is used.

2.6.3 RFID calibration mode

In the RFID calibration mode, the distance to the optimum tag write/read position and AGC value required
for properly writing/reading data on/from RFID tags are obtained through a calibration, the obtained
values are set on the printer automatically, and they are reflected in the printer operation.
To write/read data on/from RFID tags with the bar code printer, it was necessary to manually set a
distance to the write/read position and an AGC value, used for detecting the target tag, with @003
command and in the system mode. However, these are automatically done in the RFID calibration mode.

2.6.4 Information mode

In the information mode, the total feed amount counted during feeding and printing operations is
displayed on the LCD in units of centimeter and inch.
Printing of the feed amount is performed on request.
20