Endress+Hauser Proline Promass E TB2 HART Operating Instructions Manual page 63

Proline Promass E TB2 HART
Endress+Hauser
Parameter overview with brief description
Parameters
Level of flow fluctuation Specify the extent measured
values fluctuate due to
changes in the process.
Result
Depending on the selection
made here, a recommended
value range is displayed
when entering the reaction
time (damping) of the local
display or the outputs.
Display damping Set the reaction time of the
local display to fluctuations in
the measured value caused
by process conditions.
Damping output 1-2 Set the reaction time of the
current output signal to
fluctuations in the measured
value caused by process
conditions.
Measuring mode output 1-2 Select the measuring mode
for current output.
Operation mode totalizer 1-3 Define how the totalizer
totalizes the flow.
Assign process variable Select the process variable for
low flow cut off.
On value low flow cut off Enter the on-value for the
low flow cut off.
Off value low flow cut off Enter the off-value for the
low flow cut off.
Pressure shock suppression Enter the time interval for
signal suppression (= active
pressure shock suppression).
Description Selection/
User entry
• Slight
• Moderate
• Strong
0 to 999 s
0 to 999 s
• Forward flow
• Forward/reverse flow
• Reverse flow
compensation
• Net flow total
• Forward flow total
• Reverse flow total
• Off
• Mass flow
• Volume flow
• Corrected volume flow
Max. 15-digit, positive
floating-point number
0 to 100 %
0 to 100 s
Commissioning
Factory setting
Moderate
0 s
1 s
Forward flow
Net flow total
Mass flow
For liquids: depends on
country and nominal
diameter
50 %
0 s
63