Proline Promass E TB2 HART
Endress+Hauser
13
Repair
13.1
General notes
Repair and conversion concept
The Endress+Hauser repair and conversion concept provides for the following:
• The measuring devices have a modular design.
• Spare parts are grouped into logical kits with the associated Installation Instructions.
• Repairs are carried out by Endress+Hauser Service or by correspondingly trained customers.
• Certified devices can be converted into other certified devices by Endress+Hauser Service or at
the factory only.
Notes for repair and conversion
For repair and modification of a measuring device, observe the following notes:
• Use only original Endress+Hauser spare parts.
• Carry out the repair according to the Installation Instructions.
• Observe the applicable standards, federal/national regulations, Ex documentation (XA) and
certificates.
• Document every repair and each conversion and enter them into the W@M life cycle management
database.
13.2
Spare parts
• A few interchangeable measuring device components are identified by a spare part nameplate.
This contains information about the spare part.
• The connection compartment cover of the device contains a spare part nameplate that includes
the following information:
– A list of the most important spare parts for the measuring device, including their ordering
information.
– The URL for the W@M Device Viewer (www.endress.com/deviceviewer):
There, all spare parts for the measuring device are listed, including the order code, and can be
ordered. If available, the corresponding Installation Instructions can also be downloaded there.
å 19
Example for spare part nameplate in connection compartment cover
Measuring device serial number:
• Is located on the device and spare part nameplate.
• Can be read out via the "Serial number" parameter in the "Device information" submenu.
71109658
Repair
A0014017
91