Table of Contents
Advertisement
Proline Promass E TB2 HART
Endress+Hauser
1.
8 mm
1.
Unscrew the securing screw using an open-ended wrench.
2.
Rotate the housing in the desired direction.
3.
Firmly tighten the securing screw.
6.2.5
Turning the display module
2.
3.
1.
Loosen the securing clamp of the electronics compartment cover using an Allen key.
2.
Unscrew cover of the electronics compartment from the transmitter housing.
3.
Optional: pull out the display module with a gentle rotation movement.
Rotate the display module into the desired position: Max. 8 ´ 45 ° in each direction.
4.
5.
Without display module pulled out:
Allow display module to engage at desired position.
6.
With display module pulled out:
Feed the spiral cable into the gap between the housing and main electronics module and plug
the display module into the electronics compartment until it engages.
7.
Screw the cover of the electronics compartment firmly back onto the transmitter housing.
8.
Tighten the securing clamp again using the Allen key.
2.
4.
max. 350°
3.
8 mm
1
3 mm
Mounting
A0013713
1.
A0013905
23
Advertisement
Table of Contents
